Common Standards For Toilet Plumbing

Uninformed homeowners pay heavy later by not following the specified local plumbing codes while installing or modifying a plumbing segment. On the other hand, the wise homeowners study the plumbing codes of the area and try to abide by the corresponding specifications to a large extent. Violating the local codes may lead to wastage of time applied in installing a particular plumbing segment.

First of all, the accurate position of the toilet flange must be determined. Since the rest of the toilet setup would reside on the flange base, the measurements must be specific and accurate. According to the plumbing codes, a gap of at least 12 inches must be maintained from the wall to the center of the corresponding toilet flange.

Once the exact location of installing the toilet flanges is determined, secure the setup in place using the standard stainless screws of 3 inches each. The flanges would be screwed to the sub-floor that lies beneath the upcoming toilet fixture.

Next, the elbow that would support the rest of the toilet setup is installed in place. An elbow with 3 inch diameter and 90-degree angle is considered appropriate for holding the toilet weight.

It is always advised to wipe off the concerned floor area with a scrub brush and warm water. The washing operation removes the foreign materials sticking to the surface of the floor. If you decide to proceed ahead without removing the stack then certain associated irregularities may crop up in the scheme of things. Take the advice of an expert on the same to determine the significance of the operation.

Next, the cold water supply setup must adhere to the code specifications as well. Generally, the cold water supply point must be installed at a distance of 6 inches from the toilet structure and should be on the left of the toilet setup. Also, a distance of about 9 inches must be maintained between the wall and the toilet.

Besides these commonly applicable standards, there are a number of guidelines that must be followed during the whole revamping project. Also, you may discuss the details with the concerned plumber to save your development from getting disapproved.

Finally, Internet can be used to add to the information in hand. Visit the local web pages to gather knowledge about the local plumbing codes.

Scott Rodgers is a fine author who has been authoring on plumbing contents for a long time now. His unique guidance has given motivation to a host of workers, ranging from Blue Bell Plumbers (Need one? click here!) to East Greenville Plumbers (Need one? click here!).

Recommended Reading

Share